What are some common hot air laminator faults and solutions?

Hot air laminators may encounter some common problems in the course of use. The following is a list of some typical failure situations and the corresponding solutions:

### Trouble 1: Uneven heating or no heating

**Cause**.
– Heating element damaged.
– Temperature controller failure.
– Power supply problem.

**Solution**.
– Check and replace damaged heating element.
– Repair or replace the temperature controller.
– Check the power cord and plug for damage and make sure the power supply is normal.

### Trouble 2: Laminating film is not flat or has air bubbles

**Cause**.
– Quality problem of laminating material.
– Laminating speed is too fast or too slow.
– Incorrect hot air temperature setting.

**Solution**.
– Check the laminating material to make sure its quality is qualified.
– Adjust the laminating speed to find the optimum speed.
– Adjust the hot air temperature according to the melting point of the material.

### Trouble 3: Excessive machine noise

**Cause**.
– Worn or loose internal parts of the machine.
– Insufficient lubrication.

**Solution**.
– Check and tighten all loose parts.
– Lubricate moving parts.

### Trouble 4: Machine suddenly stops working

**Cause**.
– Circuit failure or blown fuse.
– Emergency stop switch triggered.
– Emergency stop switch triggered.

**Solution**.
– Check circuit and fuse, replace if necessary.
– Reset emergency stop switch.
– Check control system and perform necessary maintenance or replacement.

### Trouble 5: Unsatisfactory laminating results

**Cause**.
– Insufficient or excessive laminating pressure.
– Laminating material does not match the product.
– Ambient temperature and humidity effects.

**Solution**.
– Adjust the laminating pressure to the proper level.
– Select a laminating material that is suitable for the product.
– Control the temperature and humidity of the working environment.

### Trouble 6: Material does not bond after laminating.

**Cause**.
– The melting point of the laminating material is too high or not reached.
– The product surface is not clean enough.

**Solution**.
– Adjust the temperature setting to ensure that the laminating material can reach the proper melting state.
– Clean the product surface to ensure it is free of dust, oil or other contaminants.

When dealing with these problems, always refer to the user manual and operating instructions provided by the equipment manufacturer. If the malfunction is complicated or you cannot solve the problem by yourself, you should contact a professional technician for repair. Regular maintenance and inspection can prevent some malfunctions and ensure the stable operation and product quality of the laminator.

Send us your ideas and we’ll get in touch with you within 24H!

Share this post!

Request A Quote